As soon as I did it, the sample rate instantly changed from 8000 to 41100 and I was able to see the available UR242 ports in the Output Ports dropdown menu. However, I NEVER EXPLICITELY CLICKED on the YS USB audio menu entry to select it. The YS USB ASIO was the only one (correct, since no other ASIO driver was installed). In my previous tests, I activated the ASIO driver drop down menu, to check if there were other drivers available. Unfortunately this did not fix the problem and the Setup Device Form still showed no value for the output ports (with the dropdown menu still inactive), even though the Form showed “Yamaha Steinberg USB ASIO” in the ASIO Driver textbox.Īs previously, the only value I was able to change was the sample rate (default 8000), but changing to 41100 had no effect.Īt the end I discovered, almost by chance, that the problem could simply fixed as follows: Hi Ulf, I reistalled Dorico Pro 3.1 the way you suggested, which was quick and with no issues. If you are unsure, go the long way, uninstall via Control Panel and install again with the Dorico installer. Also make sure that you let reinstall the components. In the Dorico installer, at some stage you can tell it to ‘reinstall’ Dorico, that saves you the step of uninstalling. You also don’t need to uninstall via Control Panel. Hi Massimo, you don’t need to reinstall the sounds, just download the Dorico installer again and run that.
0 Comments
Leave a Reply. |